How to install the MN MODEL MN91 RC CAR differential?

Click here to buy MN MODEL MN91 RC CAR

1. Use precise tools to install brand new ball bearings on the press to ensure that the bearings are stable and durable. Pay attention to the installation position and direction of the bearings to ensure good fit with the differential case.

2. Position the odometer driving gear, align it with the positioning hole, and press it on smoothly with force. Make sure the pressing force is moderate to avoid damage to the gear or housing.

3. Install a rubber gasket in the differential case to provide necessary support for subsequent assembly. Make sure the rubber gasket is correctly positioned and firmly fixed.

4. Use the operating tool to flip the differential case and install the lower gear in place. Use your hand to gently support the upper gear to ensure good fit between the gears.

5. Install the planetary gears precisely into the housing, ensuring that the rotating gear set is aligned with the holes. This is a critical step and requires careful operation to ensure the correct installation of the gear set.

6. Position the planetary gear shaft firmly in the positioning hole to maintain the stability of the overall structure. Ensure that the planetary gear shaft and the planetary gear fit well without looseness or gaps.

7. Install wire clamps at all connection points to ensure a stable connection. The wire clamps should be installed evenly and firmly to avoid loosening or falling off during use.

8. Remove all installation tools and carefully check the installation of the differential. Make sure all parts are properly installed and firmly fixed without looseness or abnormalities.