How to install the MN MODEL MN82 RC CAR differential?

Click here to purchase MN MODEL MN82 RC CAR original parts

Use the tool to install the new ball bearing on the press. Make sure the bearing is installed smoothly and stably.
Align the positioning holes on both wings and press down to install the odometer driving gear. Make sure the gear is installed firmly.
Install the rubber gasket into the differential housing. This helps provide the necessary support and sealing.
Insert the tool into the differential housing and then turn the differential housing over.
Install the lower half-shaft gear on the tool and lift the upper half-shaft gear by hand. Make sure the gears are installed correctly and aligned.
Install the planetary gear accurately into the housing. Make sure the rotating gear set is aligned with the hole. This is a critical step and requires careful operation.
Insert the planetary gear shaft and position it firmly in the positioning hole. Keep the overall structure stable.
Finally, install the wire clamp to ensure that all connection parts are stable. Then remove the tool and complete the final finishing touches.