How to install the differential of MN MODEL MN90 RC CAR?

You can click here to buy MN MODEL MN90 RC CAR
Using the press tool, install the new ball bearing securely to the corresponding position of the differential case on the press. Make sure that the bearing is installed smoothly without shaking or sticking.
Align the odometer driving gear with the positioning hole on the differential case, and then press it into place evenly with force. Make sure that the gear is installed firmly without looseness.
Properly install the rubber gasket in the differential case to provide necessary support for the subsequent steps. Make sure that the gasket is installed flat without deformation or damage.
Use the tool to flip the differential housing, install the lower half-shaft gear on the tool, and hold the upper half-shaft gear with your hand to ensure that the gear is installed in place and meshes well.
Place the planetary gear accurately into the differential housing, ensuring that the rotating gear set is perfectly aligned with the hole. This step is critical and requires careful inspection of the meshing and installation position of the gears.
Insert the planetary gear shaft into the differential housing and ensure that it is firmly positioned in the positioning hole. Check the installation of the gear shaft to ensure that there is no shaking or jamming.
Install the wire clamp between the planetary gear shaft and the differential housing to ensure that all connection parts are firm and reliable. Check the installation of the wire clamp to ensure that there is no looseness or damage.
Complete the assembly of the differential and other components according to the specific structure and requirements of the vehicle. For example, connect the differential to the drive shaft, drive axle and other components, and ensure that the connection is firm and there is no looseness.